Electrical Connection - Renfert Top spin Manual De Instrucciones

Included in Delivery
1 Top spin
1 Stepped drill, size: large
1 Quick Start Guide
1 Allen key (10, Fig. 1)
1 Replacement threaded pin (see end of the instructions for use)
1 Laser sticker set
Installation
Unpacking
⇒ Check to ensure all delivery parts are complete (compare "Included in Delivery").
Setting Up
⇒ Place the unit on a level and stable base.
⇒ Decide which working position you require (Fig. 2).
Change laser warning label
⇒ Remove the laser warning label in your language from the sticker set and stick over the present
warning label (13, Fig. 1).

Electrical Connection

⇒ Unroll the power cable (8, Fig. 1) and insert the plug into the socket.
Operation
Switching on / off
The unit is switched on and off via the sensor surface (9, Fig. 1).
⇒ To switch the unit on, touch the sensor surface with the palm of your hand for 1 second. Do not apply
pressure.
The drilling motor is activated when the drilling table (2, Fig. 1) depressed.
Only activate the drilling motor when there is a drill in place!
Auto Off
If the unit is not used for a duration of 3 minutes, it automatically switches off.
Setting the Drilling Depth
The drilling depth can be set at the adjustable depth stop (12, Fig. 1) underneath the drilling table. If
necessary, carry out trial drillings.
The drilling depth changes approximately 0.1 mm for each click on the depth stop.
Drilling
⇒ Place the dental arch onto the drilling table (2, Fig. 1) and align the target laser (1, Fg. 1).
⇒ Hold the dental arch with both hands.
⇒ Press the drilling table down as far as it will go.
♦ The motor will be activated automatically and begin drilling from the bottom of the dental arch.
⇒ Guide the drilling table back up.
♦ The motor will stop when the drilling table has reached its original position.
- 3 -
EN