Product Description - Renfert Top spin Manual De Instrucciones

Hazard and Warning Information
EN
General Information
► If the device is not used in compliance with the supplied instructions, the safety of the device
can no longer be guaranteed.
► The device may only be operated using a mains cable with the country-specific plug system.
Any necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
► The device may only be plugged into outlets which are connected to the protective conductor
system.
► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► Check connection cables (such as power supply cords), tubes and housing (i.e. the key-pad)
regularly for damage (i.e. kinks, cracks and porosity) or signs of ageing.
Devices with damaged connection cables, tubes or housing parts or other defects must not be
operated!
► Defective devices must be put out of service immediately. Remove the mains plug and ensure
the device is not used. Send the device for repair!
► Only operate the device under supervision.
► Please observe the national accident prevention regulations!
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with.
For Germany these are BGV A3 in relation with VDE 0701-0702.
Specific Instructions
► Caution! Laser beam! Laser class 2! Do not look into the laser beam!
► Do not use the device for milling. Risk of injury if the drill breaks.
► Never touch the drill when the unit is connected to the power supply. There is a risk of injury if
the unit is accidentally activated!
► Do not operate theTop spin with long, untied hair or loose / baggy clothing. If anything gets
tangled up or drawn in there is a risk of injury.
► Do not touch the drill when in motion.
► The unit should only be activated when the model is securely placed in position
► When drilling, do not hold the model directly over the laser beam - risk of injury.
Authorized Persons
Operation and maintenance of the device may only be performed by qualified personnel.

Product Description

Component Groups and Functioning Elements
See Fig. 1 (on inside cover)
1 Target laser
2 Drill table
3 Operation display
4 Dust Drawer
5 Base
6 Upper stop position
7 Spindle lock
8 Mains supply cable with plug
9 Sensor surface (on / off)
10 Allen key
11 Dust protection hood
12 Depth stop (under the drill table)
13 Warning Laser
- 2 -