Commissioning; Alignment; Sensing Range - SICK GTE6L Instrucciones De Operación

7

COMMISSIONING

-Px1xx
-Px2xx
-Px3xx
-Px4xx
L.ON, PNP: Q (≤ 100 mA)
-Px1xx
-Px2xx
-Px5xx
-Px6xx
D.ON, PNP: Q (≤ 100 mA)
-Nx1xx
-Nx2xx
-Nx3xx
Nx4xx
L.ON, NPN Open Collector Q (≤ 100 mA)
-Nx1xx
-Nx2xx
-Nx5xx
-Nx6xx
D.ON, NPN Open Collector Q (≤ 100 mA)
7 Commissioning
7.1

Alignment

7.2

Sensing range

8
Align sensor on object. Select the position so that the red emitted light beam hits the
center of the object. You must ensure that the optical opening (front screen) of the sen‐
sor is completely clear [see
Check the application conditions: Adjust the mounting position so that the sensing
range and remission capability are within the corresponding diagram [see
(x = sensing range, y = operating reserve).
During this process, an object can only be detected in front of a background if the
remission capability of the object is significantly higher than that of the background or
if the distance between the object and the background is sufficiently long.
+ (L+)
Q
‒ (M)
+ (L+)
Q
‒ (M)
+ (L+)
Q
‒ (M)
+ (L+) + (L+)
Q Q
‒ (M) ‒ (M)
figure 0].
+ (L+)
Q
‒ (M)
+ (L+)
Q
‒ (M)
+ (L+) + (L+)
Q Q
‒ (M) ‒ (M)
+ (L+)
Q
‒ (M)
see figure 2].
8025471 / 24.06.2020 | SICK
Subject to change without notice