Commissioning; Alignment - SICK HL18 Instrucciones De Uso

7

COMMISSIONING

7 Commissioning
7.1

Alignment

16
Table 9: Q1 output ACTIVE states for Dark Switching variants with Alarm/Health and adjustable
time delay
HL18-Xxxxx_
HL18-Yxxxx_
HL18-Jxxxx_
HL18-Kxxxx_
No Time Delay Q1 = D.ON
-xxxxxC
-xxxxxF
Q1 = D.ON
-xxxxxI
1
Adjustabl
-xxxxxM
e ON
Delay
-xxxxxI Q1 = L.ON
2
-xxxxxD
-xxxxxG
Q1 = D.ON
-xxxxxK 1
Adjustabl
-xxxxxN
e OFF
Delay
-xxxxxK 2 Q1 = L.ON
1 L/D Selection Switch in in the "D" Dark Switching position
2 L/D Selection Switch in in the "L" Light Switching position
Red light: Align the sensor with a suitable reflector. Select the position so that the red
emitted light beam hits the center of the reflector. Tip: Use the signal strength light bar
on the back of the sensor to help you align it correctly. The sensor must have a clear
view of the reflector, with no object in the path of the beam [see
ensure that the optical openings of the sensor and reflector are completely clear.
Figure 1: Alignment
figure 1]. You must
8017290.1A15 / 2020-12-14 | SICK
Subject to change without notice