7.1
GENERAL INFORMATION
Check the connection to the electric network so that it complies with the
rules mentioned in paragraph 5.3.
7.2
STARTING AND WORKING (see chapter 4.6)x SP20 / SP30
The machine mixes at one speed without pre-established times and the worker
must carry out any operation by hand.
The following procedure must be followed:
- Lift the stainless steel protection .
- Insert the plug into the proper socket.
- Turn on the power, positioning main switch to ON.
- Lower the stainless steel protection.
- Press the push-button START N. 3 to let the machine start:
AND Nr. 1-3-4 switch to change speeds
- Make sure that the rotation direction of the basin corresponds to the
direction indicated by the arrow placed on the basin itself.
- Press the back push-buttons for 1st and 2nd speed to change the
machine speed.
7.2
MANUAL STARTING AND WORKING (see chapter 4.6) x SP40 / SP50
The machine mixes at high or low speed without pre-established times and
the worker must carry out any operation by hand.
The following procedure must be followed:
- Lift the stainless steel protection
- Insert the plug into the proper socket
- Turn on the power, positioning the general switch (Nr. 1) to 1
- Put the AUT/MAN selector (Nr. 6) in the Man (manual) position.
- Lower the protection
- Press the green push-button to let the machine start:
Nr. 4 for 1st speed or
Nr. 5 for 2nd speed.
- Make sure that the rotation direction of the basin corresponds to the
direction indicated by the arrow placed on the basin itself.
- Press the green push-buttons for 1st and 2nd speed to change the
machine speed.
7TH CHAPTER
USE AND WORKING
OF THE SPIRAL MIXERS
14