7.3
AUTOMATIC STARTING AND WORKING (see chapter 4.6) x SP40 / SP50 (*)
The machine mixes at high or low speed and the working times can be
pre-established through two electronic timers.
The following procedure must be followed:
- Lift the stainless steel protection
- Insert the plug into the proper socket.
- Turn on the power, positioning the general switch (Nr. 1) to 1.
- Put the AUT/MAN selector (nr. 6) in the AUT (automatic) position.
- Lower the protection.
- Set the two electronic timers(nr.7) from 0 to 99 minutes as you like,
(see page 24-25)
- Press one of the green push-buttons (nr.4-5) to let the machine start.
- Make sure that the rotation direction of the basin corresponds to the
direction indicated by the arrow placed on the basin itself.
- When the work is finished, the machine stops automatically.
(*) for model with timer
7.3
DISENGAGEMENT
- When the work is finished, turn off the power bringing main switch
position 0.
7.4
NOTES
The machine starts only when the cover is well closed.
ATTENTION: The machine can be stopped at any time, pressing the red
STOP button (Nr. 2) or lifting the protection.
15
to the