2
Installing the mounting bracket and safety wire onto the speakers
2-1
Install the mounting bracket onto the speaker using the included screws.
Position both the upper and lower part of the mounting bracket at the third hole to install (see the figure below; only VXL1-8 have one location).
Install the safety wire at the topmost hole position.
CAUTION
• Use the included safety wire.
• If the included safety wire is not long enough, consider the weight
of the speaker and the installation conditions, and procure an ap-
propriate safety wire.
Screw hole for safety wire installation
Upper
side
Screw hole for safety wire installation
Screw hole for mounting
bracket installation
VXL1B-24/VXL1W-24/VXL1B-16/VXL1W-16/VXL1B-8/VXL1W-8 Installation Guide
Screw hole for safety wire installation
Screw hole for mounting bracket installation
Screw hole for mounting
bracket installation
Screw hole for mounting
bracket installation
Installing the speakers
VXL1-8
VXL1-16
Screw hole for mounting
bracket installation
VXL1-24
Lower
side
7