Connecting The Cables - Yamaha VXL1B-24 Guia De Instalacion

Installing the speakers
3
Setting the directionality (VXL1-24, VXL1-16 only)
3-1
Set the directionality by using a flat head screwdriver to operate
the Vertical Coverage Selector on the back of the speaker.
At this time, when you want to expand the area of coverage downwards,
set the switch to WIDE.
NORMAL
NORMAL
8
VXL1B-24/VXL1W-24/VXL1B-16/VXL1W-16/VXL1B-8/VXL1W-8 Installation Guide
Vertical Coverage
Selector
WIDE (expands range down)
WIDE
4

Connecting the cables

4-1
Remove the Euroblock plug from the speaker.
NOTE
Although there are two different speaker connectors for top and bottom,
they are the same (connected in parallel internally). You can use either
one.
4-2
After loosening the terminal screws of the Euroblock plug with
a flat-blade screwdriver, insert the cable into each terminal and
tighten the screws.
Tug on the cables to make sure that they cannot be pulled out.
NOTE
When installing outdoors, run the cables through the included terminal
cover before inserting them into the connector.
Terminal cover
Euroblock plug
NOTE
Use a flat head screwdriver with a blade width of 3 mm or less.