Installing The Speakers; Pre-Installation (Cable Preparation) - Yamaha VXL1B-24 Guia De Instalacion

Installing the speakers

You can use the included mounting bracket to install the speaker on a
wall. Before installation, make sure the installation area can support the
weight of the speaker. Do not install on plasterboard.
NOTICE
When installing speakers, make sure the power amplifier is turned off.
CAUTION
Do not install the speakers horizontally, as the speakers may fall.

Pre-installation (cable preparation)

Strip the cable insulation as shown in the figure and connect the cables.
NOTE
Do not use solder to plate stranded wires, as this may cause the wires to
break.
7–8 mm
Compatible cable (Max): AWG12 (3.5 sq)
6
VXL1B-24/VXL1W-24/VXL1B-16/VXL1W-16/VXL1B-8/VXL1W-8 Installation Guide
1
Attaching the bracket base to the wall
1-1
Place the included template on the wall, to decide where the
holes should go for the screws and cables.
1-2
Make holes in the wall for the cables, and pull the cables from
the amplifier out through the holes.
1-3
Install the bracket base onto the wall. Position the narrow part of
the bracket base down (towards the floor).
The bracket base holes should be 5.3 mm in size.
Bracket base (screws
not included)
VXL1-24: 635 mm
VXL1-16: 315 mm