Operate On Slopes; Operation Tips; Maintenance; General Maintenance - GreenWorks Pro MO60L03 Manual Del Operador

EN
8.5

OPERATE ON SLOPES

Do not mow on the slopes with incline more than 15°.
If you are not comfortable, do not mow on a slope.
Please keep a low self-propelled speed when you
mow on a slope.
• Do not go up and down on a slope, mow across the
face of the slope. Be careful when you change the
direction on a slope.
• Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or
embankments.
8.6

OPERATION TIPS

• Do not try to override the operation of the start
button or start handles.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other
debris.
9

MAINTENANCE

Remove the safety key and battery pack from the
machine before maintenance.
Keep the motor and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
WARNING
WARNING
WARNING
WARNING
CAUTION
English
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
9.1

GENERAL MAINTENANCE

• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use
water.
9.2

REPLACE THE BLADE

20
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove blades with a wrench or a socket:
• Turn nut (24A) to the right to remove blade A (20),
spacer (25A) and positioner (22);
12
CAUTION
CAUTION
22
23
21
25
25
24
24
22
23
WARNING
WARNING