Yamaha EDL7000SE Manual Del Usuario página 52

45 PERIODIC SERVICE
NOTICE
8 Before replacing
fuse, determine why the fuse
blew and make any necessary
repairs. Failure to follow this
procedure may result in serious
damage
electrical system. Refer to the
troubleshooting section of this
manual or a Yamaha dealer for
specific information.
[Engine model ··· Z482, D722]
(1) Fuse 3 A : External connection terminal block
(2) Fuse 10 A : AC (Accessory Line)
(3) Fuse 5 A : Glow
(4) Fuse 15 A : Solenoid
(5) Fuse 15 A : (spare)
(6) Fuse 10 A : (spare)
„
Fan Belt
‹
Adjusting fan belt tension
WARNING
To avoid personal injury:
8 Be sure to stop the engine and
remove the key before checking
the belt tension.
8 Be sure to reinstall the detached
safety shield after maintenance
or checking.
A deflection of between 12 to 14
mm (0.47 to 0.55 in.) when the
Proper fan belt tension
belt is pressed in the middle of
the span.
1. Stop the engine and remove the key.
2. Apply moderate thumb pressure to belt between
pulleys.
3. If the belt tension is not as specified, loosen the
lock nut and turn the adjust nut to get the belt
tension within the specified range.
a blown
to the generator
4. Tighten up the lock nut.
5. Replace fan belt if it is damaged.
NOTICE
8 If belt is loosen or damaged
and the fan is damaged, it
could result in overheating or
insufficient
correctly or replace the belt.
(1) Fan belt
(A) 12 to 14 mm (0.47 to 0.55 in.)
(2) Bolt and adjust nut
(3) Lock nut
charging. Adjust
(under load of 98 N (22.1 lbs.))