Publicidad
Idiomas disponibles
Idiomas disponibles
CEBORA S.p.A.
Supplied gears
Wire diameter
Wire speed range
Protection degrees
Wire Feeder dimensions
Wire Feeder weight
4.2
Commands and fittings (fig. 4).
BA Connector.
commands. The
described in par. 4.3.
BB Central adapter.
Fitting for the welding torch.
GB
BC Wire Test key. It's a lever push-button with
two temporary positions:
- pressing it towards up the wire advance is
obtained; the wire exits from the torch at the
set up speed, without gas spillage and
current generation at the Power source
output.
- pressing it towards down the wire
regression is obtained; the wire re-enters in
the torch at the set up speed, without gas
spillage and current generation at the Power
Source output.
NOTE: Only retract the wire by very short
lengths, as the wire is not wound back
onto the spool.
BA
BI
3300361-A
n° 2 Ø 40 mm,
with Ø 1,0 and 1,2
mm wire V race.
n° 2 Ø 40 mm,
with Ø 0,8 and 1,6
mm wire V race.
0,8 ÷ 1,6 mm.
0,5 ÷ 22 m/min.
IP 21 S.
(W x H x D) 215 x
250 x 350 mm.
8,3 Kg.
Connector
for
external
available
signals
BL
BC
BD Connector. To connect to the Power
Source. Connect the service cable of the
Power Source - Wire Feeder extension (2).
BE Gas hose fitting. Connect the gas hose of
the Power Source - Wire Feeder extension
(2).
BF Socket.
Power Source - Wire Feeder extension (2).
BG Quick-fitting socket.
output. Connect any hose provided on the
torch for torch cleaning.
BH Quick-fitting valves. Connect the hoses of
the Power Source - Wire Feeder extension
(2) marked with the adhesive red and blue
bands.
are
Match the hose and valve colours correctly.
BI Quick-fitting valves. Connect the hoses
marked with red and blue adhesive bands
leaving the water-cooled welding torch.
Match the hose and valve colours correctly.
BL Gas Test Key. It's a lever push-button with
two temporary positions:
- pressing it toward up the "Air Test"
function is obtained; a compressed air breath
exits from the nozzle of the torch for torch
cleaning;
- pressing it toward down the "Gas Test"
function is obtained; the gas exits from the
torch without welding wire advancing and
without generating Power Source output
current.
BM
BB
BN
BH
BG
fig. 4
Connect the power cable of the
Compressed air
BE
BD
BF
18-03-2016
12
Publicidad
