Publicidad
Idiomas disponibles
Idiomas disponibles
CEBORA S.p.A.
BM Quick-fitting valve. Compressed air intake
for
torch
cleaning.
compressed air line.
BN Hole. For welding wire intake.
4.3
BA connector (external signals).
NOTE: All command signals must be connected
to contacts free from voltage.
Motor +/-. Output voltage for Push-Pull torch
motor drive.
Wire Inch. Digital input, functionally parallel
connected to the Wire Inch signal coming
from Robot. If Wire Retract is active Wire
Inch is not operative.
GND-ISO. 0 V reference for external signals.
Start +/-. Start command input, functionally
parallel connected to the start command of the
BB central adapter and to the Arc-On signal
coming from Robot.
Wire Retract. Digital input, functionally parallel
connected to the Wire Retract signal coming
from Robot. If Wire Inch is active Wire
Retract is not operative.
Gas Test. Digital input, functionally parallel
connected to the Gas Test signal coming from
Robot.
+5V/GND. Output voltage for eventual Push-Pull
torch motor encoder supply.
Gas nozzle. Digital input. Connect to an external
gas flow meter (optional kit).
Collision Protection +/-. Digital input. Is
repeated to the Robot Interface with 10 ms
max. delay; doesn't produce any effect on
welding process.
+12V_ISO. Output voltage for external signals
supply.
3300361-A
Connect
to
the
4.4
BD connector (CANbus-1).
Power Source – Wire Feeder.
Pin
A
Gnd (Earth)
B
C
0Vdc (Wire Feeder Control
D
power supply).
+70Vdc (Wire Feeder Control
E
power supply).
F
+8V (CAN-1 power supply)
G
CAN-1 high
H
I
CAN-1 low
J
Gnd (CAN-1 power supply)
5
MAINTENANCE.
Periodically make sure that the Welding System
equipment and all connections are in proper
condition to ensure operator safety.
Periodically open the panels of the Wire Feeder
to check the internal parts. Periodically remove
dirt or dust from the internal parts, using a jet of
low-pressure dry compressed air or a brush.
Check the condition of the internal power
connections and connectors on the electronic
boards; if you find "loose" connections, tighten
or replace the connectors.
Remove any dirt or metal dust from the wire liner
and gearmotor unit, using a jet of low-pressure
dry compressed air or a brush.
Make sure that the mechanical parts of the roller
unit are not worn to the point where they need to
be replaced.
Check the condition of the electrical connectors
and pneumatic fittings; replace if damaged.
After making a repair, be careful to arrange the
wiring in such a way that the parts connected to
the power supply are safely insulated from the
parts connected to the welding circuit.
Do not allow wires to come into contact with
moving parts or those that heat up during
operation.
Mount the clamps as on the original machine to
prevent, if a conductor accidentally breaks or
becomes
disconnected,
occurring between Power Supply and the welding
circuits.
13
Signal
NU
NU
NU
a
connection
from
18-03-2016
GB
Publicidad
