Brushing Teeth - Nevadent ADVANCED Instrucciones Breves

Modes
The toothbrush 10 has 3 different modes.
Depending on the desired mode, press the
on/off switch 7 repeatedly when
switched on, until the corresponding symbol
is lit:
Clean mode
- for cleaning teeth with high pulsation
Sensitive mode
- gentle brushing for cleaning teeth with
sensitive gums
NOTE: if you are not used to using an elec-
tric toothbrush and you have comparatively
sensitive gums, you can use this mode for
the first 1 to 2 weeks, and then switch to
Clean mode later.
Massage mode
- pulsating brushing to massage your
gums

Brushing teeth

1. Remove the toothbrush 10 from the bat-
tery charger 12.
2. Switch on the toothbrush using the on/
off switch 7.
3. Press on/off switch
til the function display 8 for the desired
mode is lit.
NOTE: switching over to another mode must
be done quickly after the last button press of
the on/off switch
1 second). Pressing the on/off switch
approx. 2 seconds after the last button press
will switch the toothbrush off.
7 repeatedly un-
7 (within approx.
4. Switch off the toothbrush using the on/
off switch
5. Moisten the bristles, apply some tooth-
paste, and only switch on the tooth-
brush 10 again when the brush head 1
is already in your mouth.
6. Slowly guide the brush head 1 from
tooth to tooth without exerting too much
pressure. Carefully clean all tooth sur-
faces, the inner surfaces of the teeth
and the tooth edges.
Figure A: the recommended brushing
time is at least 2 minutes, divided up
into 30-second periods for each area of
the mouth (bottom right, bottom left, top
right, top left). The toothbrush 10 indi-
cates these intervals by two brief inter-
ruptions.
NOTE: if the brush head 1 is pressed against
the teeth too hard, the LED 6 lights up red.
You should then reduce the pressure.
7. The toothbrush signals the end of a cy-
cle of 2 minutes with three short inter-
ruptions. Switch off the toothbrush using
the on/off switch
brush head 1 from the mouth only
when the toothbrush 10 has been
switched off.
7
7.
7. Remove the
GB
11