Fein MSfo870-1d Instrucciones De Uso página 19

OBJ_BUCH-0000000342-001.book Page 19 Wednesday, March 6, 2019 3:14 PM
Mounting the wheel guard MSfov852-1,
MSfov852-1-180 (figure 6)
Remove the 3 hexagon nuts using the open-
jawed wrench SW 8.
Mount the wheel guard on the set screws in
the required working position.
Fasten the wheel guard with the 3 washers
and hexagon nuts.
Mounting the hand protection
(figure 7).
Unscrew the auxiliary handle.
Mount hand protection and tighten it by
screwing in the auxiliary handle.
Connecting to the power supply.
The power tool is provided ex works without
a plug.
Recommendation: As a protective measure
against overload, equip the power tool with a
matching FEIN motor-protection plug.
The plug is to be installed by a
WARNING
qualified electrician.
Before starting operation,
WARNING
check the rotation direction of
the output shaft without a grinding accessory
mounted, and have it corrected if required.
The rotation direction is marked on the
power tool with an arrow.
Fig. 6
Fig. 7
Hand protection
The output voltage and fre-
WARNING
quency of the power supply
must correspond with the data on the type
plate of the power tool.
Using FEIN frequency converters ensures
reliable operation of the power tool.
Follow the steps in the operating instruc-
tions of the frequency converter.
en
19
Hexagon nuts
Washers
Wheel guard