Transport; Storage; Maintenance And Care; Troubleshooting - Kärcher IVC 60/30 Tact2 Manual Original

Warning
Crush hazard. Never hold your
hands between the dirt contain-
er and the intermediate ring or
put them near the lifting mecha-
nism while locking. Lock the container by
pressing the sliding bow with both hands.
Cleaning the device
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
 Wind up the mains cable and hook it
into the cable hook.
 Wind the suction hose around the slid-
ing bow.
 Insert the floor nozzle and the suction
pipe into their respective holder.
 Place the appliance in a dry room and
secure it from unauthorized use.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Release the park brakes and push the
appliance by the push handle.
 Grab the appliance by the chassis, not
by the sliding bow to load it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
16

Storage

Exchanging the flat pleated filter
Note: 2 persons are required to remove the
suction head.
 Unscrew the connection plug of the
thermal probe at the intermediate ring.
 Release and remove the suction head.
 Release and remove the filter cover.
 Replace the flat pleated filter.
 Insert and lock the filter cover.
 Insert the suction head carefully, align
and lock it.
 Screw in the connection plug of the
thermal probe at the intermediate ring.
Clean the thermal probe
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The con-
tainer is unlocked and lowered.
 Pull the container out by the handle.
 Clean the thermal probe and the protec-
tive cover with a moist cloth.
 Replace the battery and lock it with the
sliding bow.

Troubleshooting

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
 Check cables, plugs, fuse, socket and
thermal probes.
 Turn on the appliance.
Vaccum turbine is running but the
machine is not sucking in dust/dirt
Note: With correct direction of rotation a
strong airflow can be felt out of the opening
of the exhaust muffler. Air is suctioned with
incorrect rotation direction.
Illustration
 Check the direction of rotation of the
motor. Exchange the poles on the appli-
ance plug if the rotation direction is
wrong.
EN
– 4