FujiFilm X-T1 Manual Del Usuario página 21

Focus-Frame Selection Focus-Frame Selection
X-T1 Owner's Manual: P 45
The procedure for selecting the focus point varies with
the option chosen for AF mode.
■ Single Point AF
The procedure for selecting the focus point is the same
as for AREA in the previous fi rmware version.
Zone AF
■
Press the function button (Fn6) to dis-
play the focus zone. Use the selector
to position the zone or press DISP/BACK
to return the zone to the center of the
display.
To choose the number of focus frames
in the zone, rotate the rear command
dial.
Rotate the dial right to cycle through zone sizes in the
order 5 × 5, 3 × 3, 5 × 3, 5 × 5..., left to cycle through
zone sizes in reverse order, or press the FOCUS ASSIST
button to select a zone size of 5 × 3. Press MENU/OK to
put your selection into eff ect.
Tracking (Focus Mode C Only)
■
Press the function button (Fn6) to dis-
play the focus frame. Use the selector
to position the focus frame, or press
DISP/BACK to return the frame to the cen-
ter of the display. Press MENU/OK to put
your selection into eff ect. The camera
will track focus on the subject while the
shutter button is pressed halfway.
R Manual focus-frame selection is not available when wide/
Focus zone
tracking is selected in focus mode S.
Burst Mode Focus-Frame Selection Burst Mode Focus-Frame Selection
When the DRIVE dial is in the CH (high-speed burst)
position, the number of focus frames available in
focus mode C drops and the maximum zone size is
restricted to 5 × 3.
Single point
ENGLISH
Changes and Additions
Focus frame
Zone Wide/Tracking
EN-5