Getting Started; Operation - Klarstein DR. BEEF II Manual Del Usuario

GETTING STARTED

Remove all packaging material.
Clean the unit as described (see Maintenance and Cleaning).
1. Place the drip tray in the appliance from above.
2. The temperature controller should be switched off. Insert the control unit with
the heating element into the unit.
3. Fill the drip tray (8) with cold water so that there is a distance of approx. 1 cm
between the water surface and the heating rods.
4. Place the grill grate on the appliance.
5. Then connect the power plug to a mains outlet.
Note: The grill grate must not touch the heating elements.

OPERATION

1. Turn the temperature control knob (4) to the desired position. The indicator
light (6) lights up. The heating element (9) heats up immediately. Let the
appliance warm up for 5-10 minutes before you start grilling.
2. Now you can place the food on the grill rack (1). Deep-frozen food must first
be defrosted before grilling.
3. To grill the food evenly, it should be turned frequently. The grilling time
depends on the food being grilled.
4. To switch off the grill, turn the temperature control knob to the OFF position.
5. You must not remove the grill grate (1), the control unit (5) and the drip tray (8)
until the appliance has cooled down completely.
Grill times
Meat type
Fillet of beef
Hamburger
Veal escalope
Pork chop
Lamb chop
Note: For safety reasons, the unit switches off automatically when you remove
the control unit from the base.
Grill time (in minutes)
8-15
8-15
5-8
12
4-8
EN
15