Makita DCO140 Manual De Instrucciones página 5

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Indicator lamps
5 Check button
6 Thumb screw
7 Shoe
8 Slide switch
9 Collet nut
SPECIFICATIONS
Model
Collet chuck capacity
Rated speed (n)/ No load speed (n
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for cutting gypsum, wood, plastic
and soft wall tiles.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Explanation of general view
10 Shaft lock
11 Tighten
12 Loosen
13 Collet cone
14 Bit
15 Projections
16 Circular guide
17 Knob
18 Vacuum cover
3 mm, 6 mm or 1/8", 1/4"
)
0
D.C. 14.4 V Model
D.C. 18 V Model
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
ENE012-1
GEA010-2
DCO140
–1
30,000 min
313 mm
1.6 kg
D.C. 14.4 V
BL1415N / BL1430B / BL1440 / BL1460B
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B /
CORDLESS CUT-OUT TOOL SAFETY
WARNINGS
1. Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by your hand or against the body
leaves it unstable and may lead to loss of control.
2. The cutter bit shank must match the designed
collet chuck.
3. Only use a bit that is rated at least equal to the
maximum speed marked on the tool.
4. Hold the power tool by insulated gripping
surfaces only, because the cutter may contact
hidden wiring. Cutting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
5. Wear eye protection and dust mask.
6. Ventilate your work area adequately.
7. Check the bit carefully for cracks or damage
before operation. Replace cracked or damaged
bit immediately.
19 Tool
20 Hose 28
21 Hose for vacuum cleaner
22 Vacuum cleaner
23 Dust collector
24 Limit mark
25 Holder cap cover
26 Screwdriver
27 Brush holder cap
DCO180
3 mm, 6 mm or 1/8", 1/4"
30,000 min
313 mm
1.5 - 1.8 kg
D.C. 18 V
BL1860B
DC18SH
–1
GEB123-2
5