Control Panel; Operating Modes Of The System - Cebora 366 Manual De Instrucciones

CEBORA S.p.A.
6

CONTROL PANEL.

The Cebora SOUND TIG ROBOT Welding System equipments may operate independently from the
Robot System, or in integrated mode as part of the Robotic Welding System.
The integration between the Cebora Welding System and Robot System is determined by the Robot
function, in the "Second Functions" menu (par. 10.2):
 Robot function active (rob On)
 Robot function not active (rob OFF)
NOTE: This Instruction Manual refers to the Power Sources arts. 366, 367 and 368 in Robot applications,
and deals exclusively with "integrated" operation.
NOTE: With the Robot function active (rob On) the arc ignition is available only with "high frequency",
the ignition by contact (crawls) is disabled.
6.1

Operating Modes of the System.

With the Robot function active (rob On), the System offers 3 Operating Modes:
 Parameter Selection Internal mode, to enable the Control Panel to operate the Power Source
operating settings without disabling the Robot function;
 Tig mode, for Tig welding, with parameter set by Robot Terminal;
GB
 Job mode, for welding with spots preset by the user.
For more detailed informations consult the Cebora Robot Interface Instructions Manual.
6.1.1 Parameter Selection Internal mode.
In Parameter Selection Internal mode, the Control Panel has full control of the Welding System
functions, while selections from the Robot Terminal are blocked.
In Parameter Selection Internal mode it is possible to call up one of the saved programs and change its
parameters, to perform welding tests with the new values.
NOTE: Selection of the operating mode (key AR) is not active, because operation in Robot systems
allows only "2-stage" mode (led F lit).
NOTE: The welding command Arc-On is the only signal that must always be provided from the Robot
Terminal in all operating modes.
The Control Panel commands and signals are described in par. 7.
6.1.2 Tig mode.
In Tig mode the Tig Welding parameters are setting from Robot Terminal.
The selection between Tig-AC or Tig-DC is carried out from Robot Terminal by means of digital signal
Job 0/DC-AC. The condition is indicated by leds AX and AV on the Control Panel.
The selection between Tig-CONTINUE or Tig-PULSED is carried out from Terminal Robot by means of
digital signal Job 1/Pulsed On. The condition is indicated by leds B and E on the Control Panel.
The welding current and wire speed variations are obtainable from Robot Terminal by means of the
analog regulations of Welding Current and Wire Speed. The value of the welding current is visualized
on the display O on the Control Panel.
6.1.3 Job mode.
NOTE: The term "Job" refers to a working point realized from the user by adjusting available parameters
for Tig welding, and then saved (stored) in a memory area called a "Job number".
In Job mode it is possible to call up a previously saved working point, developed starting from a Tig
welding condition defined by the user and saved in a "Job number".
3300279-C
= "integrated" operation;
= "independent" operation.
34
17-03-2016