Electronic Oven Control; Display; Start/Enter; Off/Cancel - Sears Kenmore 665.75002 Manual De Uso Y Cuidado

ELECTRONIC OVEN CONTROL
1Hf
I_E MOIL AVE_CE. _ ILAy
H_vv-*
5 6 7 8
2 3 4
( (! /,,,o
HUL!II KIN
9 10 11 12
1. Display
2. CLOCK
3. TIMER
4. Oven Light/Oven Lockout
5. Oven Selectors
6. SELECT CLEAN
TM
Self-Clean
(on some models)
7. Temperature Setting
8. Timed Cooking
9. HOUR
10. MINUTE
11. STAR,ENTER
12. OFF/CANCEL
When power is first supplied to the appliance, make sure the
surface burners are in the OFF position. Everything on the display
will light up for 5 seconds. Then the time, "PF" and a picture of a
cooktop will appear on the display.
Any other time "PF" and a picture of a cooktop appears, a power
failure occurred. To remove "PF" and to reset the clock, press
OFF/CANCEL.
When the oven is in use, this display shows time, temperature
and what command pads have been pressed.
When the oven is not in use, the display will show the time of day.
The START/ENTER pad begins any oven function except the
Timer. If not pressed within 5 seconds after pressing a pad,
"START?" will appear on the display as a reminder. If not pressed
within 5 minutes after pressing a pad, the display will show the
time of day and the programmed function will be cancelled.
The OFF/CANCEL pad stops any oven function except for the
Clock, Timer and Cooktop or Oven Lockouts.
After pressing OFF/CANCEL, the display will show the time of
day or, if the minute timer is also being used, the time remaining.
This is a 12 hour clock and does not show a.m. or p.m.
To Set:
1. Press CLOCK.
2. Press the HOUR/MIN "up" or "down" arrow pads until the
correct time of day shows on the display.
3. Press CLOCK or START/ENTER.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheated
• Function has been entered
Three tones
• Invalid pad press
Four tones
• End-of-cycle
• Reminder, repeating each minute after the end-of-cycle tones
9