Cub Cadet SurePath Pro Z Serie Manual Del Operador página 11

Seat Arm Rest
To adjust the height of the arm rests, lift
the arm rest and rotate the knob under
the arm rest right or left to increase or
decrease the height. See Figure 2-17.
Figure 2-17
Seat Air Ride
The air ride can be adjusted up or down
using the height adjustment lever (a) on
the front of the seat. Press the lever to
the left (+) to raise the height of the seat
and to the right (-) to lower the height of
the seat. See Figure 2-18.
(a)
Figure 2-18
Checking Tire Pressure
WARNING
Maximum tire pressure under any circumstances
is 12 psi on rear tires and 25 psi on front tires.
Equal tire pressure should be maintained at
all times.
Inflation Pressure
Rear Tires — 10-12 psi max
Front Tires — 20-25 psi max
The tires on your mower may be over-
inflated for shipping purposes. Reduce
the tire pressure before operating the
mower. Recommended operating tire
pressure is 10-12 psi on rear tires and 20-
25 psi on front tires.
Lubrication & Grease Points
Before operating the mower, refer to the
Product Care section of this manual to
check the lubrication and grease points.
Grease and lubricate if necessary.
Connecting the Battery Cables
WARNING
California PROPOSITION 65: Battery
posts, terminals, and related accessories contain
lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION
When attaching battery cables, always connect
the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables
on your equipment may have been left
disconnected from the terminals at the
factory. To connect the battery cables,
proceed as follows:
1. Using the lever on either side of the
back of the seat, lift up on the lever
and tilt the seat forward locking it
in place with the seat prop. Remove
the bolts and hex nuts from the
manual bag.
NOTE: The positive battery terminal
is marked POS. (+) (a). The negative
battery terminal is marked NEG. (–)
(b). See Figure 2-19.
NOTE: If the positive battery cable
(c) is already attached, skip ahead
to Step 4.
2. Slide the red boot (d) from the
positive battery terminal (a) and
attach the red cable (c), with
the vertical mount bolt (e). See
Figure 2-19.
(e)
(e) (e)
(c)
(a)
(f)
(b) (b)
Figure 2-19
3. Position the red boot (d) over
the positive battery terminal (a)
to insulate it and help protect it
from corrosion.
4. Attach the black cable (f), to the
negative battery terminal (b) with
the vertical mount bolt (e). See
Figure 2-19.
NOTE: If the battery is put into
service after the date shown on top/
side of battery, charge the battery
prior to operating the machine.
Connecting to the GPS Network
See the Controls & Operation section
for instructions on connecting to the
GPS Network.
(d)
S 2 — A
ection
& S -U 11
SSembly et p