Mounting The Side Shelf; Placing The Grease Bucket; Connecting To A Power Source - Pit Boss PB700FB1 Montaje Y Operación

9. MOUNTING THE SIDE SHELF

Parts Required:
1 x Side Shelf (#20)
4 x Screw (#A)
4 x Locking Washer (#C)
4 x Washer (#B)
Installation:
• From underneath, fasten the side shelf to the side panel of the main
barrel using four screws, locking washers, and washers.
NOTE: Do not tighten screws completely until all screws have been
installed. Once all screws are installed, then tighten securely.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.

10. PLACING THE GREASE BUCKET

Parts Required:
1 x Grease Bucket (#18)
Installation:
• Place the grease bucket on the spout hook on the end of the Main
Barrel. Ensure it is level to avoid grease spills.
• The unit is now completely assembled.

11. CONNECTING TO A POWER SOURCE

STANDARD OUTLET
•
This appliance requires 110-120 volt, 60 Hz, 250 W. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses 110-120 volts and a fast-blow fuse to protect the board
from the ignitor.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the ignitor draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
•
Disconnect the ignitor from the main wiring harness. Use the manual
start-up procedure. A Pit Boss® unit can operate using a 12 volt,
100 watt inverter plugged into your automobile outlet. To use the
automatic ignitor, it is recommended to use a minimum of a 1000
watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
9
20
10
18
11
11