Assembling The Side Burner Shelf; Mounting The Side Burner Shelf; Installing The Side Burner Valve; 19. Mounting The Burner Knobs - Pit Boss Pro PB1100PSC2 Manual Del Usuario

16. ASSEMBLING THE SIDE BURNER SHELF

Parts Required:
1 x Side Burner Panel (#16)
1 x Side Burner Shelf (#18)
3 x Screw (#A)
Installation:
• Flip the Side Burner Shelf upside-down. Mount the Side Burner Shelf onto
the Side Burner Panel with three washers, locking washers, and screws.

17. MOUNTING THE SIDE BURNER SHELF

Parts Required:
5 x Screw (#A)
5 x Locking Washer (#C)
5 x Washer (#B)
Installation:
• Mount the Side Burner Shelf onto the end cap of the gas barrel with
five washers, locking washers, and screws.
18. INSTALLING SIDE BURNER VALVE
Installation:
• Secure the side burner valve onto the side burner panel using two
pre-installed screws on side burner valve.
• Fasten screws only half-way to allow easier installation in next step.

19. MOUNTING THE BURNER KNOBS

Parts Required:
4 x Burner Knob (#20)
1 x Burner Knob Bezel (#21)
Installation:
• First, install the Burner Knob Bezel onto the front of the Side Burner
Panel. Ensure the two large key holes align with the screws. Note
illustration 19A.
• Move the knob bezel vertically down to have the small end of key hole
touch the screws and then tighten the screws. Note illustration 19B.
• Place Burner Knobs into the Burner Knob Bezel and protruding valve
stems, making certain to align the flat portion of the stem with the
flat portion of the knob. Push each Burner Knob onto the stem until it
is firmly seated. Note illustration 19C.
16
A
A
17
A
C
B
18
19A 19B
21
19C
20
16
18
15