Securing The Chimney; Mounting The Front Shelf; 10. Mounting The Side Shelf - Pit Boss PLATINUM LAREDO 1000 PB1000PL Manual De Instrucciones

8. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Cap (#6)
1 x Chimney Stack (#7)
4 x Screw (#C)
Installation:
• Locate the chimney opening on the top of the Main Barrel. From the
outside, secure the chimney to the corner of the Main Barrel using four
screws. The screw will fasten to the self-clinching nut on the inside of the
Main Barrel. Next, secure the Chimney Cap onto the top of the Chimney
stack by rotating the Chimney Cap screw into the Chimney Stack.
NOTE: Adjust the chimney cap to affect the airflow inside the main
grill. If cooking at a low temperature, keep the cap more open.
Ensure the chimney cap allows for air to escape.

9. MOUNTING THE FRONT SHELF

Parts Required:
1 x Front Shelf (#15)
4 x Screw (#A)
Installation:
• Locate the holes on the front panel of the Main Barrel. From the inside,
mount the Front Shelf to the Main Barrel using four screws.
TIP: Fasten all four screws halfway first, then fasten completely.

10. MOUNTING THE SIDE SHELF

Parts Required:
1 x Side Shelf (#14)
5 x Screw (#B)
Installation:
• First, install two screws onto the right side fo the Main Barrel and
leave about 1/4 inch (6-7mm) out. Note illustration 10A.
• Mount the Side Shelf onto those two screws, then push the the Side
Shelf towards the front of the unit to lock into place. Secure the Side
Shelf into its locked position by using three screws on the underside
of the Side Shelf. Note 10B.
IMPORTANT: Avoid using the Side Shelf or Front Shelf to move or
lift the grill. The weight of the unit will cause the shelves to break,
which is not covered by warranty.
10
8
6
9
15
10A
10B
FROM BELOW
14
7