Installing The Front Shelf Brackets; Mounting The Front Shelf; Securing The Bottle Opener - Pit Boss PB0820D3 Manual Del Usuario

7. INSTALLING THE FRONT SHELF BRACKETS

Parts Required:
2 x Front Shelf Bracket (#21)
6 x Screw (#A)
6 x Washer (#B)
6 x Locking Washer (#C)
Installation:
• Attach one front shelf bracket to the front of the grill barrel by using
three screws, locking washers, and washers. Install each screw half-
way, then tighten completely when all three screws are mounted and
aligned properly.
• Repeat the same installation for the other front shelf bracket.

8. MOUNTING THE FRONT SHELF

Parts Required:
1 x Front Shelf (#22)
2 x Screw (#D)
2 x Nut (#H)
Installation:
• From underneath, insert the screw (from the inside) into the front
shelf and the front shelf bracket, then lock it with the nut. Repeat the
installation for the other side of the front shelf.
NOTE: When installed correctly, the front shelf can be raised (for use)
and lowered (for storage) with ease.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.

9. SECURING THE BOTTLE OPENER

Parts Required:
1 x Bottle Opener (#12)
Installation:
• Remove the two pre-mounted screws for the bottle opener on the
side of the hopper. Install the bottle opener in the same location using
the two screws previously removed.
10
7
21-1
21-2
B
A C
8
D
H
22
9
12