Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPLEMENT ASSEMBLY
Ensure that gear lever and PTO lever are disengaged.
1. Lower the stop-lever A, engage the clutch lever B, and lock them with stopper C (Fig 19-20). Set the
throttle at halfway position.
2. Set engine for starting as described in the engine manual.
3. Slowly pull the starting handle until the hooking system is engaged, then give a strong pull placing
the foot (fig 21). The rope handle must always be grasped with ONE HAND ONLY, to prevent the
engine "kicking back".
When the engine has started, allow it to run idle for some minutes to allow oil to lubricate all moving parts.
Grip the clutch lever on the handlebars to allow the locking stop spring to release, making sure not to fully
release the stop-lever A (fig19-20) which will stop the engine running. Engage and locate the speed control
rod to the desired speed position. If the gear does not engage immediately release the clutch lever slightly
and "feel-in". When the gear is engaged, release the clutch lever slowly and fully until the machine starts.
To engage drive to the implement, engage the clutch lever and locate the control rod in its forward position.
If engagement is not immediate, release the clutch lever slightly and feel-in.
45
Publicidad
Tabla de contenido
