MADER E-MT370C Manual De Instrucciones página 56

Arado mecánico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

of the machine, and turn the pulley as to start the motor.
If a spark is not seen between the plug electrodes, see if the plug wire connections are tight. If currents still
does not reach the electrodes, change the plug.
If the motor still does not start with a new sparking plug, the trouble is to be found in the electrical system,
points, condenser, coil or the other parts and it is advisable to turn to the nearest service point or a
specialized shop.
2) Diesel motor does not start.
Make the following checks in the order given.
The breather hole in the fuel tank is not clogged.
The fuel tank is at least half full. If surrounding temperature is very low, fill the tank, located on the head
and closed with a rubber plug, with motor oil. If the motor still does not start, purge the fuel lines of air
according to the instructions given by the motor manual. If the motor still does not start, go to the nearest
service point or a specialized shop.
3) The gears don't engage.
Adjust the clutch, unscrewing the adjusting screw B (fig 17) until the clutch disengages properly. To replace
and assemble the clutch refer to page 42.
STORAGE
If the machine is not to be used for a long period of time it is advisable to take the following precautions:
Empty the carburettor.
Empty the oil motor.
Lubricate the cylinder introducing few drops of the same kind of oil used for the motor through the plug
hole and turning the motor over several times without starting it. If it is a diesel motor remove the injector
by unscrewing the two bolts which fasten it to the head and pour some oil into the hole.
Lean the motor and the machine thoroughly.
Protect the teeth of the bar with the front protection and control that the blade doesn't escape from the
side of the bar.
When restarting the operations check that all security devices (motor-stop, reverse motion/PTO, clutch
lever stopper) are working.
TOOL KIT
Each machine comes supplied with:
1Use and maintenance manual for engine
1 set of spanner for the engine
1 use and maintenance manual for machine
1 set of spanner for the machine
GUARANTEE
Guarantee is recognized according to the terms and rules indicated on the documents furnished with the
machine. For rental use, warranty is nor granted.
Note: the engine guarantee is recognized by the builder of the engine according to the terms and rules
55

Publicidad

Tabla de contenido
loading

Productos relacionados para MADER E-MT370C

Tabla de contenido