Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
indicated on the documents furnished with the machine.
PARTS TO BE REPLACED BECAUSE WORN OUT:
Rotary hoe knives (side and central knives)
Cutter bars and cutter section
Cutter bars tooth
Cutter bars hitches
Lawn mowers cutting bars
Adjustment slides for cutting height
Floor sliding slides.
PARTS WHICH MUST BE REPLACED FOR PERIODICAL MAINTENANCE PROCEDURES
Motor oil filters
Carburettor filters
Motor air filters
Gear box oil
Motor oil
Implements transmission oil
Transmission belts
ORDERING SPARE PARTS
The when ordering spare parts, be sure to give the complete code of the part required to the authorized
dealers as given in the parts catalogue. The serial number of the machine or of the implement must also be
given (see page 4, fig B).
Our company reserve the right to modify at any time and without notice any parts of accessory, if necessary
from technical or commercial point of view.
CODE NUMBER
HOW TO REPLACE THE CLUTCH
1-
mount the clutch on the motor
2-
position clutch lever A on the machine
3-
approach the motor with the clutch to the gear box and fix it, paying attention that the two teeth of
the push-holder ring B are low as indicated in the picture 58.
4-
Connect the clutch driving cable.
ATTENTION!
Never disassemble the inner parts of the clutch since being the spring strongly charged, it would be
dangerous to disassemble the unit without the fit equipment.
NOTE
At the end of the operation, it is advisable to let the machine with the clutch disengaged, that is actioning
the clutch lever and blocking it with the fit stop bracket C (fig 59).
56
Publicidad
Tabla de contenido
