Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WHEELS ''SUPER-BITE" (Antidrift)
Those wheels are particularly recommended to mow on sloping ground. Coupled to pneumatic wheels they
increase both the traction and lateral stability of the machine. (fig 44).
WHEEL TWINNING
The wheels 4.00-8 and 4.0-10 can be twinned installing two 6cm spacers D (fig.45) between the two wheels
(see wheel spacers).
WHEEL SPACERS
These spacers are used to widen the track and thus increase the stability of the machine on sloping ground.
They are mounted between the wheels and the hubs and widen the track by 6cm on each side. They are
necessary to fit wheels 5.00-12'' on the two-wheels tractor 710 (fig 46).
BALLASTS FOR WHEELS
These ballasts are used to make the machine heavier and to have therefore a higher tractive force. They can
be used for ploughing or ridging. They must be fixed to the wheel hubs with two of the four nuts fastening
the wheels (fig 48). See table no.1.
ROTARY HOE WHEEL
This wheel is very useful when moving the machine on long distance because it holds the hoe up off the
ground and makes travelling easier (fig 51).
CUTTER BARS SIDE PROTECTIONS
53
Publicidad
Tabla de contenido
