Rechargeable Batteries; Safety Instructions For Batteries - Cembre NR-25B Manual De Uso Y Mantenimiento

LED lights (6)
The 2 LEDs allow you to illuminate the work area and are useful in low light conditions. They turn on auto-
matically when the impact wrench is started and turn off 10 seconds after the motor has stopped. They flash
when the tool goes into auto-shutdown "Sleep" mode.

5.1) Safety instructions for batteries:

If the machine is defective, remove the batteries.
Do not use faulty or deformed batteries!
Do not open batteries!
Do not touch or short circuit battery contacts!
Optimal battery storage temperature is between 10 and 30 °C (50 and 86 °F).
Remove the battery from the machine to transport the machine.
For transportation of Li-Ion batteries please refer to page 19.
Batteries are supplied with a charge ≤ 30%, to maximise energy level, it is necessary to fully
recharge them before use.
A completely charged battery provides 100% of its energy between -20°C and + 50°C (- 4
and +122 °F).
Only use the battery charger supplied following the instructions provided.
Approximately 90 minutes are required to charge a fully depleted battery with supplied charger.
To optimize the energy supplied by the batteries, it is advisable to use both at the same time
with the same level of charge.
11

5. RECHARGEABLE BATTERIES

Protect battery from water and moisture!
Do not expose batteries to naked flames!
A slightly acidic, flammable fluid may leak from defective Li-ion batteries!
If battery fluid leaks out and comes into contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks out and comes into contact with your
eyes, wash them with clean water and seek medical attention immediately!
At the end of their life, always recycle batteries.
Never discard batteries with domestic waste, they must be sent to appropriate
collection centres for disposal.
EN