Kohler Dual Opto 1103128 Instrucciones De Servicio página 8

Thermistor Retainer
Thermistor
O-Ring
Mixer Valve
Remove the Thermistor Wiring Loom
CAUTION: Valve may have high internal pressure. Use caution
when removing the thermistor.
Remove the thermistor retainer and locking clip then disconnect
the thermistor from the mixing valve.
NOTE: Replace thermistor O-ring if worn or leaking. The O-ring
may have remained in the mixer valve housing when the thermistor
was removed.
Set the wiring loom aside.
1117891-9-B
Screw
Locking Clip
8
Thermistor
Wiring Loom
Connector Tab
Grommet
Circuit
Board
Kohler Co.