Cleaning Before Use; Before Switching On - Jocel JC-432LNFI Manual De Instrucciones

All manuals and user guides at all-guides.com
INSTALLATION
Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 16℃ and 43℃. Avoid locating your
Fridge/Freezer near a heat source, eg, cooker, boiler or radiator. Also avoid direct sunlight in out-buildings
or sun lounges. If you are placing your Fridge/Freezer in an out-building such as a garage or annex ensure
that the Fridge/Freezer is placed above the damp course, otherwise condensation will occur on the
Fridge/Freezer cabinet. Never place the Fridge/Freezer in a wall recessed or into fitted cabinets or fumiture
when your Fridge/Freezer is working, the grille at the back may become hot and the sides warm. It must
therefore be installed so that the back of the Fridge/Freezer has at least 9cm(31/2") of free space and the
sides have 2cm(3/4"). Do not drape the Fridge/Freezer with any covering.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be affected and may cause you
Fridge/Freezer to work incorrectly. Once the Fridge/Freezer is placed in its final location, adjust the leveling
feet at the front by turning them.

Cleaning before use

Wipe the inside of the Fridge/Freezer with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing in the Fridge/Freezer. The external parts of the Fridge/Freezer can be cleaned
with wax polish.
Before plugging in YOUMUST
Check that you have a socket which is compatible with the plug supplied with the Fridge/Freezer. If not see
the section called ELECTRICAL INFORMATION

Before switching on!

DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE/FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
-39-