SOMFY S&SO-RS100 io HYBRID Instrucciones página 56

EN
a
Step A1 : Setting / resetting of end limits in manual mode with the wired
control point
This procedure is only applicable to roller shutters without rigid links and without stops.
At 2) the roller shutter rises each time you press the button.
From 3), in set mode:
The roller shutter moves more slowly during the first few seconds of movement.
•
The movement of the roller shutter is delayed on start-up. It is therefore necessary to press
•
the buttons as in 4) and 6) before the roller shutter moves in order to confirm the settings.
Position the roller shutter at its half-way position.
1)
On the wired control point, press six times on
2)
and press once on
movement by the roller shutter:
The drive is in set mode.
→
The drive remains in set mode for ≈ 10 min.
Move the roller shutter to the desired upper (or lower)
3)
end limit.
▲
Press once on
4)
back and forth movement by the roller shutter:
The setting for the first end limit is confirmed.
→
Move the roller shutter to the desired lower (or upper)
5)
limit.
▲
Press once on
6)
two back and forth movements by the roller shutter:
The setting for the end limits is confirmed and the drive exits set mode.
→
The procedure for modifying the end limit settings is identical to the initial setting procedure.
To modify the settings at a later time, repeat step A1
b
Step A1 : Setting / resetting of end limits in semi-automatic mode with the
wired control point
This procedure is only applicable to roller shutters without rigid links and with stops, and roller
shutters with rigid links and without stops.
At 2) the roller shutter rises each time you press the button.
From 3), in set mode:
The roller shutter moves more slowly during the first few seconds of movement.
•
The movement of the roller shutter is delayed on start-up. It is therefore necessary to press
•
the buttons as in 4) and 6) before the roller shutter moves in order to confirm the settings.
Position the roller shutter at its half-way position.
1)
On the wired control point, press six times on
2)
and press once on
movement by the roller shutter:
The drive is in set mode.
→
The drive remains in set mode for ≈ 10 min.
54
▼
until there is back and forth
▼
and press on until there is
▼
and press on until there are
▼
until there is back and forth
Copyright© 2014-2017 SOMFY ACTIVITES SA, Public Limited Company. All rights reserved.
▲
1) 2)
x 6
3) 4)
x 1
5) 6)
x 1
a
.
1) 2)
▲
x 6
S&SO-RS100 io Hybrid
2.5 s
2.5 s
x 2
2.5 s
2.5 s