SOMFY S&SO-RS100 io HYBRID Instrucciones página 62

EN
2.4.3. Deactivating / Reactivating the Smart Protect function with the wired control point
The Smart Protect function can be deactivated with the wired local control point. The S&SO-RS100 io
HYBRID then works with standard obstacle detection while guaranteeing the protection of the roller
shutter.
Once deactivated, the Smart Protect function can be reactivated with the wired control point,
following the same procedure.
Position the roller shutter at its half-way position.
1)
On the wired control point, press twelve times on
2)
▲
and press once on
• The roller shutter moves back and forth.
The Smart Protect function is deactivated.
→
• The roller shutter makes two back and forth movements.
The Smart Protect function is reactivated.
→
2.4.4. Adding a Somfy io-homecontrol
Position the roller shutter at its half-way position.
1)
On the wired control point , press three times on
2)
▲
and press once on
forth movement of the roller shutter:
The radio is activated and the drive is in
→
programming mode.
The drive remains in programming mode for ≈ 10 min.
Briefly press the PROG button on the Somfy
3)
io-homecontrol local control point you want to
®
programme:
The roller shutter moves back and forth: this
→
control point has been programmed in the drive.
2.4.5. Activating/Deactivating use in a KNX installation using the setting tool
This function is only accessible outside set mode and programming mode.
Position the roller shutter at its half-way position.
1)
On the io HYBRID Setting Cable Kit, briefly press the
2)
button twice and then press the
roller shutter moves back and forth.
• If the roller shutter makes two back and forth
movements.
The function has been activated.
→
• If the roller shutter makes one back and forth movement.
The function has been deactivated.
→
To reset the end limits, deactivate this function.
2.4.6. Deleting the end limit settings: return to default automatic mode (there are 2 possible
methods)
2.4.6.1. With the wired control point
Position the roller shutter at its half-way position.
1)
On the wired control point, press nine times on
2)
and press once on
movement by the roller shutter:
60
▼
:
local control point
®
▼
until there is back and
button until the
▼▲
▼
, until there is back and forth
Copyright© 2014-2017 SOMFY ACTIVITES SA, Public Limited Company. All rights reserved.
1) 2)
x 12
1) 2)
1 2
4 3
x 3
3)
PROG. 0.5 s
1) 2)
▼▲
▼▲
x 2
1) 2)
▲
x 9
S&SO-RS100 io Hybrid
2.5 s
2.5 s
▼▲
2.5 s
2.5 s