Installation - IKEA FRAMTID DATID CG7 N Manual Del Usuario

ENGLISH

Installation

This appliance is in Class 1 (free standing
appliance).
The appliance must be used with the gas
specified on the rating plate located on
the back side of the appliance. Electrical
and gas installation and maintenance of
the appliance must be carried out by a
qualified technician in compliance with the
conditions established in the applicable
regulation documents and the ethical codes.
How to install the feet
The appliance is equipped with 4 feet that
are used for possible height alignment with
the cabinets. To fit them, tilt the appliance
and screw the 4 feet in the special threads
located in the corners (see Fig. 1).
4x
Fig. 1
All manuals and user guides at all-guides.com
Securing the cooker to the wall
Drill two holes in the wall approximately
700 mm above and 20 mm inner the lower
edge of the sides of the cooker (as shown in
Fig. 1 position F), so that they are concealed
by the cooker itself (see Fig. 2).
2x
ø 6 mm
20 mm
20 mm
F
F
~700 mm
Fig. 1
Fig. 2
20