Important Assembly Information; Assembly (Fig. A); Fasten Nuts And Bolts; Care And Maintenance - Tunturi UB 90 Pro Utility Bench Manual Del Usuario

- This equipment is designed and intended
for home and consumer use only, not for
commercial use.
Warning:
Before beginning any exercise program, consult
your physician. This is especially important for
individuals over the age of 35 or persons with
pre-existing health problems.
Read all instructions before using any fitness
equipment.
Tunturi New fitness bv. assumes no
responsibility for personal injury or property
damage sustained by or through the use of this
product.
Save these instructions!
Important assembly infor-
mation
Tools Required for Assembling the Bench:
Two Adjustable Wrenches.
‼ NOTE
• It is strongly recommended that this
equipment is assembled by two or more
people to avoid possible injury.
- Ensure Carriage Bolts are inserted through the
SQUARE holes on components that need to be
assembled. Attach washer only to end of the
Carriage Bolt.
- Use Allen Bolts or Hex Bolts inserted through
the ROUND hole on components that need to
be assembled.
- Always wait until all bolts are assembled onto
the bench before tightening the bolts. Do not
tighten each bolt right after it is installed

Assembly (fig. A)

⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least
two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around
the equipment.
• Refer to the illustrations for the correct
assembly of the equipment.

Fasten Nuts and Bolts

‼ NOTE
• Do not over tighten any component with
pivoting function.
• Make sure all pivoting components are able
to move freely.

Care and maintenance

- Lubricate moving parts with WD-40 or light oil
periodically.
- Inspect and tighten all parts before using the
equipment.
- The equipment can be cleaned using a damp
cloth and mild non-abrasive detergent. DO
NOT use solvents.
- Examine the equipment regularly for signs of
damages or wear.
- Replace any defective components immediately
and/or keep the equipment out of use until
repair.
- Failure to examine regularly may affect the
safety level of the equipment.
English
Securely tighten all
Nuts and Bolts after all
components have been
assembled in current
and previous steps.
Do not tighten all Nuts
and Bolts in this step.
9