Putting The Pxc 350 Into Operation; Inserting And Replacing The Batteries - Sennheiser PXC 350 Instrucciones De Uso

PXC350_515699_0607_SP6.book Seite 7 Dienstag, 5. Juni 2007 11:47 11
º
»
All manuals and user guides at all-guides.com
Putting the PXC 350 into
operation

Inserting and replacing the batteries

For powering the NoiseGard Advance active noise
compensation, two AAA size batteries or rechargeable
batteries are required.
Open the battery compartments
right earcups.
º
Remove the flat batteries.
Insert the batteries as shown. Please observe
correct polarity when inserting the batteries.
Close the battery compartments º. The battery
compartment covers lock into place with an audible
click.
Notes:
– The headphones can also be used without
batteries. Switch NoiseGard Advance off before
removing the batteries (see "Switching NoiseGard
Advance on/off" on page 10).
– Always replace the two batteries (left and right)
at the same time.
– Remove the batteries if the headphones will not
be used for extended periods of time.
When the batteries are almost flat, the LED
You then have to replace the batteries.
º
on the left and
»
flashes.
7