Sauder Camden 101730 Instrucciones De Montaje página 13

Step 8
Insert the METAL PIN (QQ) into the edge of the LEFT END (B). Only insert about 1/4 of the
å
PIN into the hole.
Fasten the LEFT END (B) to the TOP (G). Tighten two TWIST-LOCK® FASTENERS.
å
NOTE: Be sure the METAL PIN (QQ) inserts into the hole in the TOP.
å
Slide the LEFT END MOLDING (V) down to the bottom edge of the LEFT END.
å
Fasten the ANGLE BRACKET (LL) on the LEFT END (B) to the LEFT END MOLDING (V). Use
å
a BLACK 9/16" LARGE HEAD SCREW (WW).
NOTE: There is no pre-drilled hole in the LEFT END MOLDING (V). The SCREW will tighten
å
into the groove.
www.sauder.com/services
QQ
V
i t h
e w
K ®
f a c
L O C
S u r
I S T -
E R S
T W
T E N
B
F A S
LL
BLACK 9/16" LARGE HEAD SCREW
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
G
WW
(1 used in this step)
101730
Caution
Page 13