Publicidad
Step 3
Place a short edge of the BASE (W) against the RIGHT END (A) so
å
the bottom edge is even with the bottom edge of the RIGHT END.
Slide the RIGHT END MOLDING (U) onto the notched edge of the
å
RIGHT END (A) until it is against the BASE (W). Slide the LEFT END
MOLDING (V) onto the notched edge of the LEFT END (B), and
then slide the LEFT UPRIGHT MOLDING (X) onto the notched edge
of the LEFT UPRIGHT (D) as shown in the lower diagram.
NOTE: The MOLDINGS should overhang the inside surfaces of the
å
ENDS and UPRIGHT. If the MOLDING overhangs the wrong surface,
remove it and slide it on again.
Fasten an ANGLE BRACKET (LL) to the LEFT END (B). Use a BLACK
å
9/16" LARGE HEAD SCREW (WW).
*U.S. Patent No. 5,499,886
å
Page 8
A
B
V
These edges should be even.
U
U
D
X
101730
Slide the MOLDING (U)
against the BASE (W).
W
These edges must be even.
BLACK 9/16" LARGE HEAD SCREW
(1 used for the ANGLE BRACKET)
www.sauder.com/services
WW
Publicidad
