Publicidad
Step 14
1
D14
O
Groove
Insert the DRAWER SIDES (D14 and D15) at an angle
å
into the slot at each end of the DRAWER FRONT (O).
3
Fasten the DRAWER BACK (D151) to the DRAWER SIDES (D14
å
and D15). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D953) inserts into the
å
groove of the DRAWER BACK (D151).
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D151
D14
D953
VIEW THE T-LOCK BOX VIDEO
2
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D953) into the grooves in the
å
DRAWER SIDES (D14 and D15) and DRAWER FRONT (O).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D15
101730
With the palm of
your hand, tap the
DRAWER BOTTOM
U n
down into the groove.
fi n
s u
i s h
r f a
e d
c e
D953
D15
O
30S
(4 used in this step)
Page 19
Publicidad
