Publicidad
Step 12
Fasten the RIGHT END (A) to the TOP (G), SHELF (K), and BOTTOM (H). Tighten six TWIST-LOCK®
å
FASTENERS. Slide the RIGHT END MOLDING (U) down the width of the TOP MOLDING (T).
Fasten four ANGLE BRACKETS (LL) to the RIGHT END (A), LEFT UPRIGHT (D), and BOTTOM (H). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (WW).
NOTE: Be sure the edges of the ANGLE BRACKETS are even with the edges of the RIGHT END, LEFT
å
UPRIGHT, and BOTTOM.
Fasten the BASE (W) to the RIGHT END (A), LEFT UPRIGHT (D), and BOTTOM (H). Use four BLACK
å
9/16" LARGE HEAD SCREWS (WW).
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
www.sauder.com/services
W
LL
LL
WW
G
D
K
H
LL
101730
T
U
u t
i t h o
e w
K ®
f a c
L O C
S u r
I S T -
E R S
T W
T E N
F A S
A
Page 17
Publicidad
