Publicidad
Step 13
Carefully turn your unit over onto its front edges. Lay the BACK (I) over
å
your unit.
Make equal margins along all four edges of the BACK (I). Push on
å
opposite corners of your unit if needed to make it "square".
Fasten the BACK (I) to your unit using the NAILS (YY).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (K).
å
NOTE: A perforation has been provided for access through the BACK.
å
Carefully cut out the hole if needed.
These holes must line
up over the SHELF (K).
Page 18
I
101730
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(23 used in this step)
www.sauder.com/services
YY
Publicidad
