dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 17

COMPACT 3.0
CABIN EXTERIOR:
5
Position the Compact in the hatch gap.
Position the foam rubber, ensuring the softest
6
part is placed on the base of the unit.
Caution: Depending on the cabin, it may be
necessary to use the (2) supplied ducts in
order for the distribution panel to be completely
adjusted.
CABIN INTERIOR:
7
Screw on (4) 8/125x70 studs approximately
10 mm with rubber washer, flat washer and
nut, and tighten.
8/125x70 Stud
M8 Nut
Rubber
Ø8 Flat
washer
wide-rimmed
washer
5
!
6
Rubber
washer
Ø8 Flat
wide-rimmed
7
washer
17
Caution! When positioning the
unit above the hatch gap, check
that the wastewater run-offs are
not blocked by the EPDM seal.
7
M8 Nut
EN
®
4
Hatch
10 mm