Assembly Carton Contents; Initial Oil Fill - Westinghouse WGen3600c Manual De Usuario

ASSEMBLY
CARTON CONTENTS
Weight hazard. ALWAYS have assistance when lifting
the generator.
1. Carefully open the carton.
2. Remove and save the carton contents.
3. Remove and discard the packing tray.
4. Unfold the top of the plastic bag enclosing the generator.
5. Carefully cut the vertical corners of the carton to access
the generator.
6. Recycle or dispose of the packaging materials properly.
CARTON CONTENTS
• User manual
• Quick Start Guide
• Bottle of SAE 10W-30 Oil
• Spark plug wrench
• Oil Funnel
If any parts are missing, contact our service team at
service@wpowereq.com or call 1-855-944-3571.
CAUTION

INITIAL OIL FILL

THIS GENERATOR HAS BEEN SHIPPED WITHOUT
OIL. DO NOT attempt to crank or start engine before
it has been properly serviced with recommended oil.
Failure to add engine oil before starting will result in
serious engine damage.
Use of 2-stroke/cycle oil or other unapproved oil types
can cause severe engine damage that is not covered
under warranty.
The included, recommended oil type for typical use is
10W-30 engine oil. If running the generator in extreme
temperatures, refer to the following chart.
Recommended Engine Oil Type
5W-30
5W-30 Synthetic
°F -20 0 20
°C
-28.9 -17.8 -6.7
Ambient temperature
1. On a level surface, remove the oil dipstick.
2. Using the supplied funnel and oil, add oil into oil filler
neck.
Note: As residual oil from the factory may remain in the
engine, add the oil incrementally near the end of the
bottle to prevent overfilling the engine. See Engine
Oil Level Check in the Maintenance section.
3. Replace the oil dipstick and hand-tighten.
Westinghouse Outdoor Power Equipment, LLC | 11
ASSEMBLY
NOTICE
NOTICE
10W-30
10W-40
40 60 80 100
4.4 15.6 26.7 37.8
120
48.9