Assembly; Carton Contents; Initial Oil Fill - Westinghouse iGen4500cv Manual De Instrucciones

ASSEMBLY

CARTON CONTENTS

Weight hazard. Always have assistance when lifting the
generator.
1. Carefully open the carton.
2. Remove and save the carton contents.
3. Remove and discard the packing tray.
4. Unfold the top of the plastic bag enclosing the generator.
5. Carefully cut the vertical corners of the carton to access
the generator.
6. Recycle or dispose of the packaging materials properly.
CARTON CONTENTS
• User manual
• Quick Start Guide/Maintenance Schedule
• 0.63 Quart (0.6 Liter) bottle of SAE 10W-30 Oil
• Spark plug socket wrench
• Oil Funnel
• Screwdriver
If any parts are missing, contact our service team at
service@wpowereq.com or call 1-855-944-3571.

INITIAL OIL FILL

THIS GENERATOR HAS BEEN SHIPPED WITHOUT
OIL. Do not attempt to crank or start engine before it has
been properly serviced with recommended oil. Failure to
add engine oil before starting will result in serious engine
damage.
Use of 2-stroke/cycle oil or other unapproved oil types
can cause severe engine damage that is not covered
under warranty.
The included, recommended oil type for typical use is
10W-30 engine oil. If running the generator in extreme
temperatures, refer to the following chart.
Recommended Engine Oil Type
5W-30
5W-30 Synthetic
°F -20 0 20
°C
-28.9 -17.8 -6.7
Ambient temperature
1. On a level surface, remove the oil access cover and oil
dipstick.
2. Using the supplied funnel and oil, add oil into the engine.
Note: As residual oil from the factory may remain in the
engine, add the oil incrementally near the end of the
bottle to prevent overfilling the engine. See Engine
Oil Level Check in the Maintenance section.
3. Replace the oil dipstick and hand-tighten.
4. Replace the oil access cover.
Westinghouse Outdoor Power Equipment, LLC | 11
ASSEMBLY
NOTICE
NOTICE
10W-30
10W-40
40 60 80 100
4.4 15.6 26.7 37.8
120
48.9