Maintenance; Replacing The Lamp - Sony VPL-CS3 Manual De Instrucciones

Maintenance

B
Maintenance

Replacing the Lamp

When the lamp has burnt out or dims, or
"Please replace the LAMP." appears on the
screen, replace the lamp with a new one. Use
LMP-C121 Projector Lamp as the
replacement lamp. The lamp life varies
depending on conditions of use.
When replacing the lamp after using
the projector
Turn off the projector, then unplug the
power cord.
Wait for at least an hour for the lamp to cool.
Caution
The lamp becomes a high temperature after
turning off the projector with the I / 1 key. If
you touch the lamp, you may scald your finger.
When you replace the lamp, wait for at least an
hour for the lamp to cool.
1
Place a protective sheet (cloth)
beneath the projector. Turn the
projector over so you can see its
underside.
Note
Be sure that the projector is stable after
turning it over.
2
Open the lamp cover by loosening a
screw with the Phillips screwdriver
(supplied with the Projector Lamp).
Note
For safety sake, do not loosen any other
screws.
3
Loosen the screws on the lamp unit
with the Phillips screwdriver. Pull out
the lamp unit by the handle.
4
Insert the new lamp all the way in until
it is securely in place. Tighten the
screws. Fold up the handle.
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
5
Close the lamp cover and tighten the
screws.
6
Turn the projector back over.
Handle
29
GB
Maintenance