IKEA VALSKAPT Manual página 13

EN
A1. ATTACH THE MOUNTING PLATE TO THE WALL
NOTE: Before tightening toggle bolts and wood screw,
make sure the bottom of the mounting plate touch the
and that the plate is properly centered under the cabinet.
CAUTION:
the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
A2. USE TOP CABINET TEMPLATE FOR PREPA-
RATION OF TOP CABINET
You need to drill holes for the top support screws, a hole large
enough for the power cord to fit through, and a cutout large
enough for the exhaust adaptor.
CABINET TEMPLATE.
CAUTION:
in the cabinet bottom.
A3. ADAPTING MICROWA VE BLOWER FOR
OUTSIDE TOP EXHAUST
1. Place the microwave in its upright position, with the top
of the unit facing up.
Blower Plate
Back of
Microwave
Blower Motor
Screw
Remove the screw that holds the blower plate to the mi
crowave. Remove and save the screw holding the blower
motor to the microwave.
2. Carefully pull out the blower unit. The wires will extend
far enough to allow you to adjust the blower unit.
3. Roll the blower unit 90° so that fan blade openings are
facing out the top of the microwave.
Before Rotation
Back of
Microwave
4. Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Top
CAUTION: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched, and that they are
properly secured.
5. Secure blower unit to microwave with the screw re
moved in Step 1. Make sure the screw is tight.
6. Replace blower plate with the screw removed in Step 1.
Make sure the screw is tight.
End B
Back of
Microwave
After Rotation
Back of
Microwave
Back of
Microwave
12