IKEA VALSKAPT Manual página 14

A3. ADAPTING MICROWA VE BLOWER FOR
OUTSIDE TOP EXHAUST
7. Attach the exhaust adaptor to the top of the blower
plate by sliding it into the guides of the blower plate.
Guide
Push in securely until it is in the locking tabs. Take care
to assure that the damper hinge is installed so that the
damper swings freely.
A4. CHECK FOR PROPER DAMPER OPERATION
Blower Plate Exhaust Adaptor
per pivots easily before mounting microwave.
gnment with your house exhaust duct after the micro
wave is installed.
A5. MOUNT THE MICROWAVE OVEN
13
Back of
Microwave
Adaptor
Back of
Microwave
Locking Tab
Damper
Back of
Microwave
IMPORTANT: Do not grip or use the handle or heat shield
during installation. Do not remove the cardboard spacers
between the heat shield and door.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord.
front hangs below the cabinet bottom shelf.
may occur from overtightening screws.
crowave oven, thread power cord
through hole in bottom of top
cabinet. Keep it tight throughout
lift oven by pulling cord.
2. Rotate front of oven up
against cabinet bottom.
Insert a self-aligning screw through top center cabinet
3.
hole. Temporarily secure the oven by turning the screw
at least two full turns after the threads have engaged.
(It will be completely tightened later.) Be sure to keep
power cord tight. Be careful not to pinch the cord,
Cabinet Front
Cabinet Bottom Shelf
Microwave Oven Top
EN
1. Lift microwave, tilt it
forward, and hook slots at
back bottom edge onto
four lower tabs of mount
ing plate.
Filler Piece
Equivalent
to Depth of
Cabinet
Recess