01_IFU-KR_COFFEEMAKER_EA6910_EN_Mise en page 1 28/05/10 14:49 Page13
KRUPS
SERIE EA69xx
!
Caution! :
Make certain to protect your work surface during cleaning and scale removal cycles,
especially if they are made of marble, stone or wood.
Press the 'Service' key to
start up the scale removal
program. The 'calc'
and
lights will flash.
!
Caution! :
Only use Krups F054 scale removal product. You can obtain scale remover from Krups Ser-
vice Centres. The manufacturer may not be held responsible for damage to the appliance
through use of other products.
Replace the water tank.
The
light will go off.
2 - First rinsing
A first rinsing is needed to eliminate the remaining scale remover.
This cycle is run automatically. It lasts about 6 minutes.
Empty your container
full of waste water.
3 - Second rinsing
At the end of the first rinsing, the 'calc' light will flash. A second automatic cycle will last 6 minutes.
13
All manuals and user guides at all-guides.com
Remove and clean the
Place a container with a
drip tray.
minimum water capacity
of 0.6 l under the coffee
outlets and under the
steam nozzle.
Once you have performed
all these operations, press
the 'Service' key.
± 6 mn
Empty the drip tray and
Empty, clean and rinse the
then put it back again
water tank and then fill it
together with the
again up to the "Max.
container as previously.
level.
± 6 mn
Empty the tank and fill it
with lukewarm water up
to the 'calc' marking.
1 - Scale removal cycle
The 'calc' light will become steady.
The scale removal cycle will have started and will be run
automatically. The pump will suck up water intermittently to
be expelled by the coffee nozzles and then the steam nozzle.
This operation lasts about 10 minutes. Once finished, the
'water tank' and 'calc' lights will flash.
Replace your water tank.
The 'calc' light will flash
and the
light will go
off.
F054
Dissolve a sachet of
Krups scale remover
F054 (40 g).
± 10 mn
Press the 'Service' key.
The 'calc' light will
become steady. The
automatic cycle will last
6 minutes.